Controllers with the exact same layout for PS3 and Xbox 360

Franman the Street Fighter Pads heavily vary in quality. While i have godlike Setsuka execution on my 360 Version, i couldnt do one Umbrella with the PS3 Version. Unfortunately i found this out during NEC 2k10, lol. The D-pad was completely different...also it gets super soft after a while. So if you train only one one those pads will be 100% different.

Then in general their quality SUCKS ASS. Madcatz is such a shit company its incredible. The Shoulder buttons stop clicking after a while, since they used a foam underneath which gets compressed to much.

Then the rubber under the D-Pad and the buttons is a prime example of bad production. The used material is just to bad, it rips off. EVERY SINGLE DIRECTION rips off. Its just that bad.

The layout and the buttons are good shaped, but the quality of this pad is not.

In the end i had to sacrifice the PS3 version which had a shit d-pad to repair all the damaged rubbers under the buttons of the 360 version.

I try hard to get rid off this pad. Then its hard to get, so dont even start to play with pads who will be sold out in a few months...not if you play competitive.
 
The FightPads tend to be duds. General rule of thumb is to avoid most of the earlier ones since those batches had all the problems.

That said, MCZ sticks are godlike.
 
How the heck did I forget this.
cyborg-pad.JPG


Saitek Cyborg Rumblepad. Like the MCZ MLG pads, you can swap the positions of the left stick and dpad.
 
do they contain micro switches?

Also I hear some compatibility issues with some other games like BioShock and Halo only that they are FPS.
 
I'll be sure to chime in on those MLG Madcatz pads when they come out. Markman(the man who upped Madcatz stick game) is involved with them and while he is aiming primarily with the FPS crowd, the ability to slap a PS3 d-pad on a 360 controller sounds absolutely wonderful.
 
You must log in or register to reply here.
Back
Top