Dragonfall
[10] Knight
Will threaded Sanwa or Seimitsu fitin there? The leftmost two buttons don't seem to have much space.
Threaded buttons and SF4 TE
- Thread starter Dragonfall
- Start date
skytoast
Videomaster
They should fit if the diameter is comparable to the stock ones. However one button close to the stick near the bracket is going to have a problem. The corner bracket plate is going to get in the way of the locking nut. So you're going to have to grind down the locking ring so that you can slip it in between.
Dragonfall
[10] Knight
When you say "grind down", do you mean making them shorter; that is, the height is the problem?
skytoast
Videomaster
Yes, they are too thick in height. That metal bracket gets in the way obviously and you cant twist the locking ring to secure the button. So the only way around this is to slip the ring underneath the bracket first then screw in the button. However the locking ring is too thick to begin with so you need to grind it down a bit. I used a Dremel tool with a grinding bit and it only took a minute or so to grind down the plastic just to get enough clearance.
Dragonfall
[10] Knight
Alright, thanks for the response.